At DP Seals we love a challenge more than most. Rubber moulding innovation is definitely in our DNA! Here are some of the ways we’ve helped engineers with design problems: Complex sub-millimetre detailing Ensuring electrical isolation Co-moulding of conductive and non-conductive materials Maintaining mating tolerances between connector pins Providing high reliability protection against fluid ingress Developing bespoke materials to survive extremely aggressive environments Producing slits in mouldings that open momentarily at the right time to produce good-sized bubbles capable of stirring effluent Producing rubber mouldings that reduce dust generation Designing and manufacturing mouldings that enhance performance, simplify cleaning and maintenance. Designing rubber safety plugs to relieve internal pressure by incorporating a thin membrane which bursts at either 40 or 70psi Producing connector seals and rubber gaskets that ensure environmental integrity against salt, dust and water Of course these are just examples of some of the challenges we’ve helped design engineers overcome. If you have a difficult design challenge why not get in touch to see if we can help you too!